Ctr Door Panels

[00si_guy86]

Hey guys, I am looking into a whole mess of JDM parts right now, and I can get some sweet deals on a lot of stuff. One thing that I really want to do is go with the CTR door panels. I found a really clean pair, but the only thing stopping me is the wiring. As we all know in Japan, the driver is on the right. In a U.S. car, that would make my passanger in charge of window operation. I know it can be done to re-wire the panels, but has anyone ever done it? If you could help me out, I could pay you for your services! If interested please let me know!:japanflag:

[2coupes]

why don't you just swap the actual door panel and reuse the window controls from your panels, they should fit, if not, then you'll need to trim where the controls go into the panel armrest

[00si_guy86]

hmm..come to think of it that would work. I would again need to make sure that the panels line up with the power window motors.

[2coupes]

why would they be off? as far as I know just the wire harness would have to be long enough, and that's not a problem, i may be forgetting something though

[Dina]

the window motor is inside the door shell not behind the panel I think if you just take your power functions and put them on the CTR panels you will be alright.

[JdmRevelations]

why not just do a DIY... rewiring and all that mess is a bit much IMO... it'll be cool but giving the pass the full control module.. nah...

[jdm93EJ1]

there is no rewiring at all both switches bezels will fit in both doors u can move them around no problem my boy has them on hsi SI all he did was took off his panels and addes the CTR ones and used his old switches