DJWoohoo
04-16-2006, 06:58 AM
Current status 13/04/06
Interior:
AC autotech S7 gauges
Blue Lumineedles
Mugen 320mm replica steering wheel
Exterior:
Vision Amber Corners
Front stock headlights with uprated H4 bulbs
Rear stock lights
JDM Siderepeaters
New JDM Ferrio rear license plate holder
Removed old single wiper back to stock two wipers
OEM carbon fibre hood
Engine:
Stock D15B7
Yonaka full catback exhaust system 2.25" piping with 4.5" muffler tip with tuner tip
4-2-1 Manifold
Decat pipe
Arospeed front upper strut bar
Suspension:
15"x6.5" +40 Rota Slipstreams in white
Toyo Proxes T1-S 195/50r15
Gmax -45mm Suspension Kit
D2 Lower Control Arms
In Car Electronics:
Clifford Alarm with solonoid boot opening
THINGS TO DO THIS YEAR!
Exterior:
Get some JDM Thin side moldings
Carbon Fibre sunroof bung kit (Awaiting delivery :P)
Spoon style lip
Get all the little inperfections out of the bodywork and give the whole car a full respray in same colour
Interior:
Change gauge cluster as I found out yesterday my speedo is not registering correctly at higher speeds and this has been probably happening for over a year now! :(
Fit my Universal Mugen Power seats with 4 point harnesses or if I can find some teg seats will fit them instead
Re colour the grey dash surround to black to match my standard black interior. :P
Just a general little tidy up as it's pretty clean inside
Fit a small ICE install complete with rear infared colour camera hooked up to headunit
Wheels/Suspension:
D2 Coilovers
D2 Camber kit front & rear
Engine:
Tune up the B16A2 I have sitting in my garage along with everything else I need to do the swap, this is not gonna be done until the exterior is finished & funds allow!
DJWoohoo
Some pics taken before the wheel change and c/f hood when I had my 17's on it.
Yes there is some rust on the rear arches that will hopefully get sorted soon. :lol:
Thanks to my mate CJ at DP for taking the snaps. ;)
These two girls who I've never seen before come over to me saying they liked my car and would I mind if they posed for pictures by my car, of course I said yes. :lol:
DJWoohoo
A few days ago I removed my hood for a while to install......... :)
my new carbon fibre hood, removed my oem crystal lights replacing them with oem stock lights & removed the short ram induction kit putting back the standard filter panel in it's place. ;)
Wasn't a bad fit in the end and doesn't look like me & my bro' did that badly. :)
Tried to line the fenders, hood lights & bumpers as best as I could until it goes into the bodyshop. :cool:
More bits should be arriving next week so expect more pics. :rockon:
DJWoohoo
Interior:
AC autotech S7 gauges
Blue Lumineedles
Mugen 320mm replica steering wheel
Exterior:
Vision Amber Corners
Front stock headlights with uprated H4 bulbs
Rear stock lights
JDM Siderepeaters
New JDM Ferrio rear license plate holder
Removed old single wiper back to stock two wipers
OEM carbon fibre hood
Engine:
Stock D15B7
Yonaka full catback exhaust system 2.25" piping with 4.5" muffler tip with tuner tip
4-2-1 Manifold
Decat pipe
Arospeed front upper strut bar
Suspension:
15"x6.5" +40 Rota Slipstreams in white
Toyo Proxes T1-S 195/50r15
Gmax -45mm Suspension Kit
D2 Lower Control Arms
In Car Electronics:
Clifford Alarm with solonoid boot opening
THINGS TO DO THIS YEAR!
Exterior:
Get some JDM Thin side moldings
Carbon Fibre sunroof bung kit (Awaiting delivery :P)
Spoon style lip
Get all the little inperfections out of the bodywork and give the whole car a full respray in same colour
Interior:
Change gauge cluster as I found out yesterday my speedo is not registering correctly at higher speeds and this has been probably happening for over a year now! :(
Fit my Universal Mugen Power seats with 4 point harnesses or if I can find some teg seats will fit them instead
Re colour the grey dash surround to black to match my standard black interior. :P
Just a general little tidy up as it's pretty clean inside
Fit a small ICE install complete with rear infared colour camera hooked up to headunit
Wheels/Suspension:
D2 Coilovers
D2 Camber kit front & rear
Engine:
Tune up the B16A2 I have sitting in my garage along with everything else I need to do the swap, this is not gonna be done until the exterior is finished & funds allow!
DJWoohoo
Some pics taken before the wheel change and c/f hood when I had my 17's on it.
Yes there is some rust on the rear arches that will hopefully get sorted soon. :lol:
Thanks to my mate CJ at DP for taking the snaps. ;)
These two girls who I've never seen before come over to me saying they liked my car and would I mind if they posed for pictures by my car, of course I said yes. :lol:
DJWoohoo
A few days ago I removed my hood for a while to install......... :)
my new carbon fibre hood, removed my oem crystal lights replacing them with oem stock lights & removed the short ram induction kit putting back the standard filter panel in it's place. ;)
Wasn't a bad fit in the end and doesn't look like me & my bro' did that badly. :)
Tried to line the fenders, hood lights & bumpers as best as I could until it goes into the bodyshop. :cool:
More bits should be arriving next week so expect more pics. :rockon:
DJWoohoo